51
SUGGESTED PRESSURE:
1.8 - 2.2 BAR
MINIMUM PROFILE DEPTH:
≥ 1.5 MM
4.4. Wheels and tyres
Proper tyre maintenance is very important. Before each use check that there are no cuts,
cracks, rips, lumps or bumps on the body of the tyre.
Check and adjust the tyre pressure with each use of the vehicle. Always do this when the
tyres are cold, which means that they have not been used in the hours prior to checking
them.
IF YOU NOTICE ANY ABNORMALITY IN ANY OF THE TYRES REPLACE
IT IMMEDIATELY
INADEQUATE PRESSURE OR POOR TYRE CONDITION CAN CAUSE:
- Unexpected bursts
- Loss of vehicle control
- Reduction of eciency in the case of too low pressure
Respect the minimum depth of the profile and if it is less, change the tyre.
Make sure that the spoke tension is correct since that can cause unstable behavior.
Check that all spokes are tight.
In the event of any spoke is not tight enough, go to your Bultaco Motors Dealer.
To Next Page
