38
The Brinco is designed for combined riding by both pedalling and with electrical
assistance from the engine incorporated into the rear wheel.
By default, the system is put in ECO mode after starting up. Press the “MODE” button
(short press) to change to TOUR or SPORT mode
[See 2.5].
The prolonged use in non-combined mode (without pedalling), at high engine torque
in steep terrain, as well as riding for a long time in SPORT mode will lead to greater
energy consumption that could cause the engine, controller or battery to overheat.
In these situations a self-protection system will be automatically activated which
progressively reduces the maximum power available as a function of the temperature and
external stress.
Activation of this self-protection system is displayed on the dashboard
throughwarning lights for the various phases:
- A first phase with a slow flashing light will slightly reduce performance
- A second phase with a rapid flashing light that will further reduce performance.
- A third phase with a continuous light that will stop the vehicle.
If the flashing warning light appears, it is recommended that the Brinco power level be
reduced and assisted by pedalling so that the warning level with a continuous light, that
would mean the vehice coming to a complete stop, is not reached.
If this state is reached the self-protection system will completely disconnect the engine’s
power source. You should wait for some time until the temperature returns to normal
operating values before starting the vehicle again.
3.4. During the ride
ECO MODE IS THE MOST RECOMMENDED
FOR USE IN AREAS WITH STEEP, LONG
SLOPES.
IF YOU ONLY USE YOUR BRINCO IN
ELECTRIC MODE, CONSUMPTION AND
TEMPERATURE WILL INCREASE AND
RIDING RANGE WILL DROP.
PLAN YOUR ROUTE IN ADVANCE.
IF THE PERFORMANCE DEMAND EXCEEDS
THE PHYSICAL LIMITS OF THE BRINCO,
THE POWER WILL BE TEMPORARILY
DISCONNECTED UNTIL THE SYSTEM
TEMPERATURE DROPS SUFFICIENTLY
ENOUGH BEFORE RESTARTING THE
VEHICLE.
To Next Page
Loading...
