Bultaco brinco - Troubleshooting; Troubleshooting Alert Signals

61
In spite of the fact that each Brinco has been carefully inspected prior to leaving the
factory, there may be circumstances beyond our control that may cause some kind of
failure.
In the event that your Brinco suers a problem, we have provided the following indications
that may help you though it. However, we recommend that you go to your Bultaco Motors
Dealer in the event of a fault.
IN THE EVENT OF A FAULT GO TO YOUR
BULTACO MOTORS DEALER
TYPE OF ALERT
SIGNAL
EFFECT OF THE
ALERT
CAUSE OF THE ALERT -
ACTION TO BE TAKEN
Slow Flashing
Quick flashing
Continuous light
Very slow flashing
The vehicle slightly reduces the performance level
as part of the protection system
It indicates that you must reduce the level of
performance requested from the Brinco and assist
by pedalling.
It indicates that you must reduce the level of
performance requested from the Brinco and help more
with the pedaling, otherwise, the vehicle will stop.
It indicates that there has been a break in the engine
temperature sensor. You must go to your Bultaco
Motors Dealer.
If it appears after the flashing light, the vehicle has
been stopped as part of the protection against a
situation of excess temperature in any of the power
elements. Allow some time for the temperature to
drop and restart your Brinco.
The vehicle reduces the performance level even
more as part of the protection system.
The vehicle stops.
The vehicle only works in ECO mode.
ALERT INDICATOR