11
Single Cup Mode
When the SINGLE cup size beverage mode is selected, the large and small cup size buttons are disabled.
To dispense a beverage, press only the dispense button of the beverage desired. The option to select which
beverage size is used can be done when creating a custom recipe or espresso dispense.
TIP: A display graphic for single cup dispensing is availble for purchase from BUNN.
CREATING A “CUSTOM” BEVERAGE
A “CUSTOM” beverage may be edited/created for any dispense switch location. It is recommended that the
touch switch graphic insert be replaced with one which matches the beverage reassignments made in this
mode. All settings can be adjusted to preference.
• Set the toggle switch to
Program mode.
STEP 1
• Advance to the Set Espresso
Shots screen.
STEP 2
• Press SELECT.
STEP 3
Use to
Navigate
PROGRAM MODE
PRESS TO ENTER
Use to
Select
SET ESPRSO SHOTS
EXIT YES
• Sets the grinder run time for a
small espresso shot.
• Navigate to the next setting.
STEP 4
Use to
Navigate
Use to
decrease
Use to
increase
SM ESP GRIND TIME
(-) #.# sec (+)
• Press a dispense switch to
perform a catch test for a grind.
• Navigate to the next setting.
STEP 5
Use to
Navigate
• Sets the espresso pump run
time for pre-infusion of tamped
coffee. Zero seconds for no
pre-infusion.
• Navigate to the next setting.
STEP 6
Use to
Navigate
Use to
decrease
Use to
increase
SM PREINFUSIONTEST SM GRIND TM
PRESS DISPENSE
OPERATING CONTROLS AND INTERFACE
NORMAL
PRGM
RINSE
continued >
MODIFYING THE TOUCH SWITCH FUNCTIONS
The function of the touch switch can be modified in three different ways:
1. Set for single cup size dispensing.
2. Disable a dispense switch.
3. Create a CUSTOM or ESPRESSO only beverage.
►
Set Espresso Shots
The sub-menus for adjusting an espresso shot are located under this option.
(-) #.# sec (+)
To Next Page
Loading...
