Bunn Crescendo - Touchless Operation Settings

14
TOUCHLESS SENSITIVITY SELECTION OPTIONS
OPERATING CONTROLS AND INTERFACE
NOTE: Your Crescendo must be fitted with a Gen 2 PCAP with software version 01.20 or higher, and the
main I/O board with software version 00.45 or higher to modify the Touch Settings on this machine.
Go to www.bunn.com to view Crescendo Programming Manual or BUNN Online Learning Center for
more information on updating.
The Sensitivity option is available for both TOUCH and TOUCHLESS operation modes. The recommended
initial setting for TOUCH is “NORMAL”, and the recommended initial setting for TOUCHLESS is “HIGH”.
• Set the toggle switch on inside
of the door to Program mode.
STEP 1
• Advance to the Calibration
screen.
STEP 2
• Press YES to enter the
Calibration sub-menu.
• Navigate through the sub-menu
until you see a screen that says
TOUCH SETTINGS.
STEP 3
Use to
Navigate
PROGRAM MODE
PRESS TO ENTER
Use to
Select
Use to
Select
CALIBRATION
EXIT YES
NORMAL
PRGM
RINSE
• Select the sensitivity level for
the TOUCHLESS or TOUCH
mode chosen on previous screen.
NOTE: It is recommended to
try “Normal” for TOUCH and
“High” for TOUCHLESS.
• Press large cup to navigate to
next option screen.
STEP 5
• Press YES to enable
TOUCHLESS dispense mode.
• Or, press NO to enable TOUCH
dispense mode.
• Press large cup to navigate to
next option screen.
STEP 6
TOUCHLESS MODE
• Press YES to enter the TOUCH
SETTINGS sub-menu.
STEP 4
TOUCH SETTINGS
EXIT YES
NO YES
SENSITIVITY
NORMAL HIGH
continued >
Use to
Select
Use to
Select
Use to
Select
Use to
Select