7
INITIAL SETUP
4
10. Once everything is installed, Place the NORMAL/
PROGRAM/RINSE switch in the NORMAL position.
11. Close door.
9
6
8
8. Reinstall hoppers into machine.
NOTE: Make sure peg on bottom of hopper drops into
locating hole on hopper platform.
9. After hoppers are installed, pull slider gates out so that
powder can pass through to dispense.
FILLING SOLUBLE HOPPERS (continued)
4. Set the hoppers on the counter, and push the slide gates
on the elbows in to close.
5. Remove hopper lids.
3. Pull the hopper forward to remove.
3
5
6. Fill hoppers with appropriate soluble products.
NOTE: Default menu is milk product left hopper, chocolate
is center hopper, and vanilla is right hopper.
7
7. Replace hopper lids.
10
11
continued >
To Next Page
Loading...
