Page 4
TROUBLESHOOTING (cont.)
Problem
Brew cycle will not start (cont.)
Automatic refill will not operate
Remedy
Refer to Service - ON/OFF switch for
testing procedures.
Refer to Service - Start switch for
testing procedures.
Refer to Service - Timer for testing
procedures.
Refer to Service - Dispense valve
for testing procedures.
Refer to Service - Control assembly
for testing procedures.
Make sure server is in place and
server present lamp is lit.
Check plumbing and shut-off valves.
(A) Direction of flow arrow must be
pointing towards brewer.
(B) Remove the strainer/flow control
and check for obstructions. Clear or
replace.
Refer to Service - Solenoid valve for
testing procedures.
Refer to Service - Limit thermostat
for testing procedures.
Refer to Service - Overflow protec-
tion switch for testing procedures.
Refer to Service - Level control board
for testing procedures.
Refer to Service - Electronic controls
for testing procedures.
Probable Cause
3. ON/OFF switch
4. Start switch
5. Timer
6. Dispense Valve
7. Control Assembly (Electronic)
8. Server not in place (SH models)
1. No water
2. Water strainer/flow control
3. Solenoid Valve
4. Limit thermostat (Electro/me-
chanical and Electronic)
5. Overflow protection switch
6. (A) Level control board & level
probe. (Electro/mechanical con-
trolled)
(B) Electronic controls
41976 031709
To Next Page
Loading...
