31
Adjustment, commissioning
Type 8045
The display shows the K-factor of the
fitting, may it have been entered or
determined by a teach-in procedure;
this K-factor is currently used by the
device
→ Edit the parameter.
K-FACtOR K=10.000
REtURN
→ Enter the K-factor (value between 0,0001 and
9999,9) of the fitting used.
→ Confirm the displayed value.
K=2.8500
OUtPUt VALiD N/Y
Is only displayed if the K-factor has been changed.
→ Confirm the entered K-factor or not.
Fig. 23 : Entering the K-factor of the fitting used
→ If you do not want to adjust another parameter, go to the "END" parameter of the Parameters menu and press
ENTER
to save the settings or
not and go back to the Process level.
English
To Next Page
Loading...
