25
Adjustment, commissioning
Type 8045
Power supply
Switch
SOURCESINK
L+ L-PEP+P-Iout
Supply
18...36 Vdc
PULSE
DO1
CURRENT
PE
DI1
PE
DO2
DO3
AO1
+
-
+
-
(*)
Fig. 21 : Possible wirings of the DI1 digital input
*) If a direct earth connection is not possible, fit a 100 nF / 50 V
capacitor between the negative power supply terminal and the earth
8. ADJUSTMENT, COMMISSIONING
8.1. Safety instructions
Warning
Risk of injury due to non-conforming operating.
Non-conforming operating could lead to injuries and damage the
device and its surroundings.
▶ The operators in charge of operating must have read and under-
stood the contents of this quickstart.
▶ In particular, observe the safety recommendations and intended use.
▶ The device/installation must only be operated by suitably trained staff.
Warning
Danger due to non-conforming commissioning.
Non-conforming commissioning could lead to injuries and damage
the device and its surroundings.
▶ Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the quickstart.
▶ In particular, observe the safety recommendations and intended
use.
▶ The device / the installation must only be commissioned by suit-
ably trained staff.
▶ Before commissioning the device, enter the K-factor of the fit-
ting used. See chap. 8.6.
English
To Next Page
Loading...
