What to do if the user parameters and the factory calibration are lost in Burkert Accessories?
Restart the Burkert Accessories device. If the issue continues, contact the retailer. Also, contact the retailer if the "LIN.LOST" message appears.
What to do if the supply voltage is too low in Burkert Accessories?
If the supply voltage is too low, ensure it's between 18 and 36 V DC. If the issue persists, contact the retailer.
What to do if Burkert Accessories device is not energized?
If the Burkert Accessories device isn't energizing, check the wiring, inspect the installation's fuse and replace it if needed. Also, verify that the installation hasn't been shut down and that the power source is functioning correctly.
Why does the displayed flow rate change very slowly in Burkert Accessories?
If the displayed flow rate changes very slowly, ensure there is fluid in the pipe and try choosing a lower filter.
Why is the displayed flow rate not stable in Burkert Accessories?
If the displayed flow rate is unstable, check that there is fluid in the pipe and consider choosing a higher filter.
What to do if the displayed flow rate is not nil but the flow rate in the pipe is for Burkert Accessories?
If the displayed flow rate isn't nil when the flow rate in the pipe is, verify that the flow rate in the pipe is indeed nil, check for bubbles in the pipe, inspect the chosen filter, and calibrate the flow zero point.
Why does the Burkert Accessories device not properly measure the flow rate?
If the Burkert Accessories device isn't measuring the flow rate accurately, verify that the K factor corresponds to the fitting being used and that the Kw coefficient hasn't been altered. Perform a teach-in procedure to determine the K factor of the fitting.
What to do if Burkert Transmitter programming/testing is unavailable?
General| Model | 8045 |
|---|---|
| Device Type | Transmitter |
| Measurement Principle | Electromagnetic |
| Output Signal | 4-20 mA |
| Material | Stainless steel |
| Lining Material Options | PTFE |
| Electrode Material Options | Stainless Steel, Hastelloy |
| Accuracy | ±0.5% |
| Ambient Temperature Range | -20 to 60 °C |
| Protection Rating | IP65 |
| Certifications | ATEX |
To Next Page
