2. INTENDED USE
Use of the product that does not comply with the instructions
could present risks to people, nearby installations and the
environment.
The product is intended to measure the electrolytic conductivity of
a solution.
▶ Use the product only in combination with foreign devices or
foreign components recommended or approved by Bürkert.
▶ Use the product in compliance with the characteristics and
commissioning and use conditions specified in the contractual
documents and in the Operating Instructions.
▶ Never use the product for security applications.
▶ Store, transport, install and operate the product properly.
▶ Only operate a product in perfect working order.
▶ Only use the product as intended.
3. BASIC SAFETY INFORMATION
This safety information does not take into account any contingencies
or occurrences that may arise during installation, use and mainte-
nance of the product.
The operating company is responsible for the respect of the local
safety regulations including for the staff safety.
Risk of injury due to high pressure in the installation.
▶ Before any intervention on the installation, stop the circulation of
fluid, cut off the pressure and drain the pipe.
▶ Observe the dependency between the fluid temperature and the
fluid pressure. See Fig. 2 chap. 6.4.
Risk of burn injury due to electrical voltage.
▶ Observe all applicable accident protection and safety regula-
tions for electrical equipment.
Risk of burn injury due to high fluid temperatures.
▶ Do not touch with bare hands the parts of the product that are
in contact with the fluid.
▶ Before opening the pipe, stop the circulation of fluid and drain
the pipe.
Risk of injury due to the nature of the fluid.
▶ Respect the prevailing regulations on accident prevention and
safety relating to the use of dangerous fluids.
5
Intended use
Type 8221
To Next Page
Loading...
