35| 46
34| 46
OPERATION MANUAL 088 PREAMP
Amplification
With this option you are able to adjust the playback volume of the PHONO MM
module to your record player.
With the left rotary switch or the navigation buttons ► ◄ on your remote control
select the option GAIN.
With the right rotary switch or the navigation buttons ▲ ▼ on your remote control
select the amplification.
Input capacitance
With this option you are able to adjust the input capacitance of the PHONO MM
module to the pickup of your record player. Usually the manufacturers of pickup
systems have recommended settings for this option. Of course you can try different
settings, whatever sounds best to your ears.
With the left rotary switch or the navigations buttons ► ◄ on your remote control
select the option LOAD.
With the right rotary switch or the navigations buttons ▲ ▼ on your remote control
select the desired input capacitance.
Independent to the desired capacitance, the input resistance is always 47kΩ.
Remote Control
SWITCHING ONOFF
The POWER button switches the preamp on or off, provided the Mains switch on
the rear panel of the preamp is set to ON and the power switch on the front panel of
the preamp is set to STBY.
INPUT SELECTION
The buttons TUNER, PHONO, TAPE, DISC, AUX, SURR activate the according
input. If you have renamed the inputs the buttons will react as follows:
TUNER:
all inputs with the character combinations TU, DAB, DVB, ADR, RADIO, RDS, 053,
993, 931, 915, 978 in its name
PHONO:
all inputs with the character combinations PH, VINYL, PL ATTE in its name
TAPE:
all inputs with the character combinations TAPE , DAT, REV, BAND in its name
DISC:
all inputs with the character combinations CD, DISC, DISC3, DISC33, DVD, BD,
MD, LD, VD, 001, 006, 052, 061, 069, 089, 992, 916, 917, 937, 963, 939 in its
name
AUX:
all inputs with character combinations which are not listed above will be toggled
through, e.g. the DAC inputs, if a DAC module is equipped
SURR:
the SURROUND input will be activated
NOTICE:
If you have multiple inputs with same characters
(for example CD1 and CD2), you will be able to toggle through those
inputs with the DISC button on your remote control.
To Next Page
Loading...
