Burmester 088 - General Instructions

41| 46
40| 46
OPERATION MANUAL 088 PREAMP
General Instructions
Please read the owner’s manual carefully and keep it safely. If you have any
questions, we ask you to contact your local authorized dealer.
Operating temperature
An operating temperature that is too high or too low may cause malfunctioning.
We therefore recommend letting the unit settle for a while after unpacking before
connecting and operating it.
Setting up
When choosing a place for your equipment please observe the following:
•
Avoid direct sunlight.
•
Do not expose the equipment to excessive heat, cold, humidity or dust.
•
Provide adequate air circulation; avoid placing the equipment in enclosures.
•
Slots and other openings in the housing are for ventilation. They must not be
covered up.
•
Please make sure that the component is not exposed to dripping water or splash
water, also don’t place boxes with liquid onto your component.
•
Open flames like candles must not be placed on top of any electronic unit.
Mains voltage
Check before operating the unit to see if the mains voltage setting shown on the
back panel below the AC mains input conforms to the voltage of your household
power supply. Any changes should only be done by an expert only.
For AC connection please use only the three-pronged power cable provided.
The grounding pin should not be bypassed under any circumstances. Connect the
component only to a wall outlet with fully functional grounding pin.
Comm. Operation
Before installation switch off all other components of your hifi system. Switch them
back on only after making sure that all connections have been made correctly and
completely.
Never try to operate the equipment when it has obviously been damaged or if liquid
has gotten into it.
DIM2\r switches the display brightness to low
DIM3\r switches the display to off mode
GLOBAL_SETUP\r opens and closes the GLOBAL menu
LAY ER _SETUP\r opens and closes the MAIN menu
PH_AMP_SETUP\r opens and closes the MC menu or the MM menu,
if equipped
NAV_UP\r equals the navigation button ▲ on the remote control
NAV_DN\r equals the navigation button ▼ on the remote control
NAV_LEFT\r equals the navigation button ◄ on the remote control
NAV_RIGHT\r equals the navigation button ► on the remote control
NAV_OK\r equals the OK button of the remote control
(confirming of input)
TYPE\r shows the type of the unit
VERSION\r shows the software version of the unit
INFO\r shows the content of the alphanumeric display