9 | 46
8 | 46
OPERATION MANUAL 088 PREAMP
FRONT PANEL
Functional overview of the preamp
1. Input selector
2. PHASE LED lights up when phase is180˚
between active input and output
3. AUDIO-LED shows up sampling of 192kHz,
if and toggles display brightness a D/A
converter module is equipped
4. Alphanumeric display shows the selected
input and the volume
5. HIGH/LOW LED indicates high
amplification
6. Volume selector controls the playback
volume
7. POWER LED lights up red when the unit
is on
8. POWER switch to switch the unit on & off
9. PHASE/DISPLAY switch key switches the
phase and toggles display brightness
10. MODULE FUNCTION switch key functions
depend on installed module
11. IR receiver for commands of remote control
12. OUTPUT/SCALE switch key
13. SETUP switch key to enter or leave
GLOBAL and MAIN SETUP
REAR PANEL
14. AC Mains Terminal
15. AC Mains Switch
16. BurLink interface RS-232 with check LEDs
17. BurLink interface USB with check LEDs
18. Phones jack PHONES
19. MAIN output balanced preamp output
20. TAPE output balanced recording output
21. SURROUND input, balanced
22. High level inputs INPUT 1 to INPUT 5,
balanced
23. Module input as ordered
24. GROUND screw for ground cable of record
player, only with PHONO modules
25. REMOTE output
26. REMOTE input
To Next Page
Loading...
