43| 46
42| 46
OPERATION MANUAL 088 PREAMP
Termi nals
The pins of the connecting terminals on the back panel must not be touched under
any circumstances. Static discharges may damage the electronic circuitry inside
the unit.
Interconnects
We supply custom-made balanced as well as unbalanced interconnect cables and
speaker cables of any length to ensure highest-quality signal paths for our
components. The impedance of our cables is ideally matched to all BURMESTER
components.
IR receiver
The IR receiver receives signals from the BURMESTER remote control and must not
be covered up by any objects.
Heat development
Be careful when touching the housing – it may get quite warm during operation.
Reset
If the unit does not react when pressing the control keys on the front panel it may be
reset to normal operation by switching it off and back on using the AC mains switch
in the back.
Lightening strikes
During the summer months, malfunctions often occur due to voltage spikes in the
power lines after lightning strikes. Completely unplugging the power cord offers the
only effective protection. Merely switching the unit off does not suffice since
voltage spikes are able to arc over separated contacts.
Fuses
The fuses are located inside the unit and should only be changed by a qualified
technician.
Warranty
We provide a three-year warranty on your Burmester device. In order for the warranty to
be valid, the device must have been connected and operated properly without
overloading, the mechanical integrity of the device must not have been compromised,
and the device must have been registered. The warranty expires if the device has been
tampered with in any way or if parts of the housing, connections or terminals have been
dismantled.
Please register your product with the serial number in the warranty certificate at:
www.burmester.services/warranty and activate your warranty extension.
Care
Never clean the housing with a wet cloth or chemical cleaning agent.
Always make sure that no liquid gets into the housing.
Battery hazard
The remote control contains batteries. Do not expose them to excessive heat.
Improper use may result in overheating, fire, explosion, smoke and gas.
To Next Page
Loading...
