Burnham K2WTC - Page 109

109
107774-01- 9/17
XIII. Operation E. Boiler Sequence Of Operation (continued)
Zone Control Status Screens (only visible if Sage Zone Panel connected)
3. Status Screens (continued)
Detail screens are accessed by selecting the “Detail” button from the “Home” screen. These screens provide in
depth operating parameter status such as “On Point”, “Off Point” and “Setpoint Source” information. Demand-specic
details are provided for Central Heat, Auxiliary Heat, Domestic Hot Water demands and outdoor air reset. Sequencer
screens are only shown when the Sequence Master is enabled.
4. Detail Screens
Figure 13.8: Detail Screen Overview
Zone Control Status
press
for
zone
cycles
><
i
Zone Panel 1
Demand Cycles
KITCHEN 45
BEDROOM S 20
BASEMENT 12
DOMESTIC HOT WATER 26
Active zones are shown by bold
& underlined numbers. Press the
zone panel to view zone cycle
counts.
To reset all zone
cycle counts press:
Reset Cycle
Counts
NOTE
Zone cycles are resettable by selecting the
reset “button” located on the information
screen.
Zone Control Status
Screen provides status and
a page links for up to four
zone panels. Individual zone
“on” status is shown by a
bold zone number with a
solid underscore. “Press” the
zone control “button” to view
individual zone cycles.