Using your DAB Micro System with Bluetooth
Let’s get started
Using your DAB Micro System with Bluetooth
25
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
If you have moved your Micro to another location, e.g.: if you go on holiday, then it’s also
a good idea to carry out a manual scan.
In DAB mode:
1. Press and release the button on the Micro or the Scan button on the remote
control to begin a search for stations. The display will change to ‘Scanning...’. A
progress bar will show the progress of the scan and the number of stations found
during the scan will also be displayed.
Prune DAB stations
You can remove the DAB stations in the station list that cannot be received in your area.
These are listed with a ‘?’ prefix.
1. Press and hold the Menu button on the Micro or on the remote control. Use the
rotary control on the Micro or the and buttons on the remote control to
move to Prune Invalid. Press the rotary control on the Micro to Select or the Select
button on the remote control.
2. Proceed to prune the invalid stations Yes No is displayed. Use the and
buttons on the Micro or on the remote control to move to ‘Yes’. Press the rotary
control on the Micro to Select or the Select button on the remote control to prune
the invalid stations from the station list. Stations with a ‘?’ prefix will now no longer be
displayed.
3. Press and release the Menu button on the Micro or on the remote control to exit from
the Menu.
Storing a DAB station preset
Your Micro can store up to 10 DAB radio stations in its preset memories for instant access
to your favourite stations.
1. Tune the Micro to the DAB radio station that you wish to preset.
2. Press and hold the button on the Micro or the Prog. button on the remote control
for approximately 2 seconds until ‘Save to Preset’ is displayed.
To Next Page
Loading...