Bush BD-618TFT - Tuning to an FM station

Using your DAB Micro System with Bluetooth
Let’s get started
Using your DAB Micro System with Bluetooth
29
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Wire radio aerial
Please make sure that the wire aerial on the back of the Micro is fully extended and
adjusted before you attempt to tune to an FM radio station (a vertical position is
recommended). This will ensure that the maximum signal strength is available when the
Micro begins to scan. Extending the aerial also ensures the best possible sound quality.
Tuning to an FM station
In FM mode:
1. Press and release the button on the Micro or the Scan button on the remote
control to scan up the frequency band. Press and hold the button on the Micro
or the Scan button on the remote control to scan down the frequency band. Your
Micro will search for the next available station and then stop on that station.
2. Press and release the Tune+ or Tune- on the front of the Micro or the and
buttons on the remote control to fine tune each frequency in 0.05MHz steps, if
necessary.
Note: If reception is still poor check that the wire aerial is fully extended or try moving
the Micro to another location.
Changing the scan setting
In FM mode:
1. Press and hold the Menu button on the Micro or on the remote control.
Scan setting will be displayed and highlighted. Press the rotary control on the Micro to
Select or the Select button on the remote control.
There are now two different options to choose from and the current setting will have a
tick next to it.
• Strong stations
The scan will only stop when a strong signal strength is received which should also
result in a better audio quality. It is possible that the station you are scanning for may
be missed using this option.