Using your DAB Micro System with Bluetooth
Let’s get started
Using your DAB Micro System with Bluetooth26
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
3. Use the rotary control on the Micro or the and buttons on the remote
control to move to the preset location that you would like to store the radio station to
(1-10).
4. Press the rotary control on the Micro to Select or the Select button on the remote
control. The display will confirm ‘Preset X saved’, where ‘X’ is the number of the preset
(1-10).
Note: If there is already an existing DAB station stored under a preset, it will be over
written when you store the new station.
Tune to a DAB station preset
In DAB mode:
1. Press and release the button on the Micro or the Prog. button on the remote
control. ‘Preset Recall’ is displayed together with the preset list.
2. Use the rotary control on the Micro or the and buttons on the remote
control to move to the Preset location and station that you would like to listen to (1-
10).
3. Press the rotary control on the Micro to Select or the Select button on the remote
control. The Micro will instantly tune to that station and begin to play.
Note: If no DAB station has been stored under the preset button, ‘Preset Empty’ will be
displayed, then the Micro will revert to the previously selected radio station after a few
seconds.
DAB display information
When listening to a DAB station you can change the information that will appear on the
display. There are several different types of information that are sent by the broadcaster.
• Dynamic Label Segment (DLS)
This is scrolling text information supplied by the broadcaster. Information could be the
name of an artist or music title, DJ’s name, contact details for the radio station etc.
To Next Page
Loading...