Using your DAB Micro System with Bluetooth
Let’s get started
Using your DAB Micro System with Bluetooth30
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
• All stations
The scan will stop for every station it receives, even if the signal strength is poor.
2. Use the rotary control on the Micro or the and buttons on the remote
control to move to and choose from the two options available. Press the rotary
control on the Micro to Select or the Select button on the remote control to confirm.
3. Press and release the Menu button on the Micro or on the remote control to exit from
the Menu.
Audio mode
The radio will automatically switch between Stereo and Mono, depending on the quality
of the signal being received but you can override this function and manually switch
between ‘Stereo’ and ‘Mono’.
Note: You may wish to select ‘Stereo’ if you are listening to your Micro using
headphones.
1. Press and hold the Menu button on the Micro or on the remote control. Use the
rotary control on the Micro or the and buttons on the remote control to
move to Audio setting. Press the rotary control on the Micro to ‘Select’ or the ‘Select’
button on the remote control.
There are now two different options of ‘Forced mono’ and ‘Stereo allowed’ and the
current setting will have a tick next to it.
2. Use the rotary control on the Micro or the and buttons on the remote
control to move to and choose from the two options available. Press the rotary
control on the Micro to Select or the Select button on the remote control to confirm.
3. Press and release the Menu button on the Micro or on the remote control to exit from
the Menu.
To Next Page
Loading...