Using your DAB Micro System with Bluetooth
Let’s get started
Using your DAB Micro System with Bluetooth
31
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Storing an FM station preset
Your Micro can store up to 10 FM radio stations in its preset memories for instant access to
your favourite stations.
1. Tune the Micro to the FM radio station that you wish to preset.
2. Press and hold the button on the Micro or the Prog. button on the remote control
for approximately 2 seconds until ‘Save to Preset’ is displayed.
3. Use the rotary control on the Micro or the and buttons on the remote
control to move to the preset location that you would like to store the radio station to
(1-10).
4. Press the rotary control on the Micro to Select or the Select button on the remote
control. The display will confirm ‘Preset X saved’, where ‘X’ is the number of the preset
(1-10).
Note: If there is already an existing FM station stored under a preset, it will be over
written when you store the new station.
Tune to an FM station preset
In FM mode:
1. Press and release the button on the Micro or the Prog. button on the remote
control. ‘Preset Recall’ is displayed together with the preset list.
2. Use the rotary control on the Micro or the and buttons on the remote
control to move to the Preset location and station that you would like to listen to (1-
10).
3. Press the rotary control on the Micro to Select or the Select button on the remote
control. The Micro will tune to that station and begin to play.
Note: If no FM station has been stored under the preset button, ‘Preset Empty’ will be
displayed, then the Micro will revert to the previously selected radio station after a few
seconds.
To Next Page
Loading...