Safety information8
Safety information
Important - Please read these instructions fully before
installing or operating
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Power source
• Only use the power supply that came with the product. Using an unauthorised power
supply will invalidate your guarantee and may irrecoverably damage the product.
• Disconnect your Micro from the mains power supply during thunderstorms.
• Always check that you have completely switched off your Micro System, before you
change or disconnect the power supply.
• Where the mains power plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
• If the Micro System will not be used for a long period of time, remove the CD and
make sure that the mains power is unplugged and the battery is removed from the
remote control.
• Only use recommended batteries or those of the same or equivalent type in the
remote control.
• Batteries are to be inserted with the correct polarity.
• The supply terminals are not to be short-circuited.
• Never throw batteries in a fire or attempt to open the outer casing.
• Batteries are harmful if swallowed, so keep away from young children.
• CAUTION: Danger of explosion if batteries are incorrectly replaced. Replace only with
the same or equivalent type.
Moisture and water
• Do not leave it in low temperatures as moisture can form inside the product, which
may damage the circuit board.
Heat sources and flames
• Do not leave it in high temperatures as electronic devices and plastic parts may warp
in heat.
To Next Page
Loading...