Bush BD-618TFT - FM Radio mode

Using your DAB Micro System with Bluetooth
Let’s get started
Using your DAB Micro System with Bluetooth28
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
compression to maximum will ‘boost’ the quiet sounds, whilst keeping the loudest sounds
at their original level.
There are 3 levels of compression:
• DRC off: No compression. This is the default setting.
• DRC low: Medium compression.
• DRC high: Maximum compression.
1. Press and hold the Menu button on the Micro or on the remote control. Use the rotary
control on the Micro or the and buttons on the remote control to move to
DRC.
2. Press the rotary control on the Micro to Select or the Select button on the remote
control. The current DRC setting will have a tick next to it.
3. Use the rotary control on the Micro or the and buttons on the remote control
to move through the options and press the rotary control on the Micro to Select or the
Select button on the remote control to confirm.
4. Press and release the Menu button on the Micro or on the remote control to exit from
the Menu
FM Radio mode
Check that your Micro is in FM radio mode. If you are not already in FM mode, briefly
press and release the Mode button on the front of the Micro or on the remote control,
until you are in FM mode (check the display). When your Micro is in FM mode it can
receive Radio Data System or ‘RDS’ information if this is being transmitted by the
broadcaster. RDS information will often include the station name, detail about the
programme and the current time.
If you were listening to an FM station when you switched the Micro off then this station
will be automatically selected when you switch the Micro back on.