Bush BD-933 - FM Scan and Audio Settings

Using your Handheld DAB Radio
Let’s get started
Using your Handheld DAB Radio
23
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
Changing the Scan setting
In FM mode:
1. Press and hold the Menu button to enter the menu options.
2. Use the or button to highlight ‘Scan Setting’. Press and release the Select button.
The current Scan Setting will have a ‘
’ to the right of the display.
There are two different options to choose from:
• Strong Stations Only
The scan will only stop when a strong signal strength is received which should also
result in a better audio quality. It is possible that the station you are scanning for may
be missed using this option.
• All Stations
The scan will stop for every station it receives, even if the signal strength is poor.
3. Use the or button to choose from the two options available and press and
release the Select button. Your Scan Setting selection will now be displayed on the
right hand side of the display, opposite Scan Setting in the Menu list. Press and release
the Menu button to return to the station display.
Audio mode
The radio will automatically switch between Stereo and Mono, depending on the quality
of the signal being received but you can override this function and manually switch
between ‘Stereo’ and ‘Mono’.
Note: You may wish to select ‘Stereo’ if you are listening to your radio using
headphones.
1. Press and hold the Menu button to enter the menu options.
2. Use the or button to highlight ‘Audio Setting’. Press and release the Select
button.