Bush BDVD72708M - Set Password; Screen Saver

GB-22
CUSTOMIZING THE FUNCTION SETTINGS
Set Password
1. PresstheSETUP button in stop mode.
2. Pressthe / buttontoselectRating.
3. Pressthe button, then press the / buttontoselectSet
Password.
4. Press the ENTER button, "Enter Password" screen will
appear.
5. Pressthenumberbuttonstoinputthecurrentpassword(If
the password has not been set yet after you purchase this
unit,itis"8888").ThenpresstheENTER button.
6. Press the ENTER button again, "Enter New Password"
screen will appear. Press the number buttons to input the
new password. Press the ENTER button. Now your new
password has been set. Be sure to remember this number!
7. Press the SETUP button or RETURN button to exit the
menu.
1. PresstheSETUP button in stop mode.
2. Pressthe
/ buttontoselectRating.
3. Pressthe button, then press the / buttontoselectParentalControl.
4. PresstheENTERbutton,"EnterPassword"screenwillappear.
5. Pressthenumberbuttonstoinputthecurrentpassword(Ifthepasswordhasnotbeensetyetafteryoupurchase
thisunit,itis"8888").ThenpresstheENTER button.
6.PresstheENTER button again to list the parental control level.
The parental lock levels are equivalent to the following ratings.
 1:KIDSAFE 2:G 3:PG 4:PG-13
 5:PG-R 6:R 7:NC-17 8:ADULT
7. Press the  /  button to select the rating from 1 to 8. Press the ENTER button to confirm.
(Rating1hasthemostrestrictionswhilerating8canvirtuallyplaybackallDVDsoftware.)
8. PresstheSETUP button or RETURNbuttontoexitthemenu.
If you forget the password, you can
erase your current password by pressing
the number button 8 on the remote four
times, then press the ENTER button to
confirm the setting (PASSWORD : 8 8 8 8).
Use Default Settings
1. PresstheSETUP button in stop mode.
2. Pressthe / buttontoselectMisc.
3. Pressthe button, then press the / buttontoselect“Use
DefaultSettings”dialoguebox.
4. PresstheENTER button, then press the / button to select
“Yes”.Pressthe ENTER button and the original setting will be
restored.Theunitwillexitsettingmenuautomaticallyandre-load
the disc in the disc tray.
MISC
Screen Saver
1. PresstheSETUP button in stop mode.
2. Pressthe / buttontoselectMisc.
3. Pressthe button, then press the / buttontoselectScreen
Saver.
4. PresstheENTER button, then press the / button to change
theOn/Offmode.
5. PresstheENTER button.
6. PresstheSETUP button or RETURNbuttontoexitthemenu.
Note:Itwilltake3-5secondstoresettheDVDplayertothefactorydefault.