Page 12
Bluetooth operation (cont)
4: Once paired the BLUE LED indicator will flash slowly.
5: When playback from the device is initiated the RED &
BLUE LED indicators will flash simultaneously
6: If using a mobile phone as an audio source, when
receiving a phone call the audio playback stops while
you receive the call. When you hang up the audio is
restored, but you will need to press PLAY once more
on the device.
NOTE: the volume output is effected by the
volume level on the audio source EG: Phone or
laptop, so make sure that is set to about 70-80%
(not too loud to avoid distortion).
Controlling the paired device
Once connected you can either use the controls on the
audio device to begin playback, skip tracks etc. Or you
can use the control buttons on the speaker unit.
1: The PLAY/PAUSE button (7 or 27) when pressed will
begin playback of the selected track on the audio
device. Press again to pause playback.
2: To skip to the next track press the NEXT button (13
or 43).
3: To skip to the previous track press the PREV button
(10 or 42).
Advanced operation
Factory reset
There may be times when you need to reset the unit
back to its original factory setting.
NOTE: the factory reset function can ONLY be
activated from DAB or FM mode.
1: Press the MENU button (24).
2: When the ‘FULL SCAN’ option appears (DAB mode) or
‘SCAN UP’ (FM mode) press either TUNE- or TUNE+
(26,46) button and locate ‘SYSTEM’, press the ENTER
button (45).
3: Use the TUNE- or TUNE+ (26,46) buttons to find
‘RESET’ and press ENTER (45).
4: Use the TUNE- or TUNE+ (26,46) buttons to select ‘Y’
(yes) and press the ENTER button (45) to perform the
reset function.
Advanced operation (cont)
Setting the time manually
You can set the time manually if the radio signal is not
strong enough to set automatically.
1: Press the MENU button (24).
2: When the ‘FULL SCAN’ option appears (DAB mode) or
‘SCAN UP’ (FM mode) press either TUNE- or TUNE+
(26,46) button and locate ‘SYSTEM’, press the ENTER
button (45).
3: Use the TUNE- or TUNE+ (26,46) buttons to find
‘TIME’ and press ENTER (45).
4: From this menu there is multiple options :- SET TIME,
UPDATE & 12/24 HOUR. Select one and press the
ENTER button (45) to proceed.
SET TIME
1: Use the CH- / CH+ buttons (44,25) to adjust the digits
and the ENTER button (45) to skip to the next setting.
2: Use the buttons outlined above to set the time and
then the date.
3: Press ENTER (45) when complete to store the
settings.
UPDATE
This setting specifies the automatic clock setting.
1: Use the CH- / CH+ buttons (44,25) to select from
ANY (sets the clock from any mode possible), DAB
(sets the clock only from DAB mode), FM (sets the
clock only from FM mode), NONE (does not set the
clock automatically and uses the manual time as
described above).
2: Press the ENTER button (45) to store the setting.
12/24 HOUR
Select how the clock is displayed.
1: Use the CH- / CH+ buttons (44,25) to select from 12
or 24. Press ENTER (45) to store the setting.
Sleep mode
Using this function you can set a timer to switch the
unit into STANDBY mode.
1: Press the SLEEP button (37) on the remote control
repeatedly to cycle through the timer options of:- 120,
90, 60, 45, 30, 15 & OFF.
User instructions
To Next Page
Loading...
