Page 6
User instructions
CD operation
Follow the below instructions to begin playback of an
audio CD.
1: Select CD mode using the instructions from the
‘Switching modes’ section.
2: Press the EJECT button (6, 50), load a disc on the
drawer (label facing upwards) and press the EJECT
button once more to close.
3: After a brief period the unit will automatically read the
disc and begin playback from track 01.
Play/pause
1: From the STOP position, press the PLAY/PAUSE
button on the main unit (7) or remote control (27) to
begin playback.
2: Press again to PAUSE playback. From the PAUSE
position pressing the PLAY/PAUSE button resumes
playback.
Stop
1: Press the STOP button on the main unit (1) or remote
control (28) during playback to stop the disc at it’s
current position.
Skipping tracks
1: Press the SKIP
button (13,43) to skip to the next
track on a disc.
2: Press the SKIP
button (10,42) to skip to the
previous track on a disc.
Fast searching tracks
1: During playback pressing the
/ TUNE+ button
(15) or
NAVIGATION/TUNE+/ button (46) on the
remote will fast forward the current track. Press the
PLAY/PAUSE button to resume playback from the
current position.
2: During playback pressing the
/ TUNE- button
(8) or
NAVIGATION/TUNE-/ button (26) on the
remote will fast rewind the current track. Press the
PLAY/PAUSE button to resume playback from the
current position.
NOTE: No audio will be heard during fast search.
Numeric buttons
During CD playback you can jump directly to a track
using only the NUMERIC buttons (22) on the remote
control. For example:-
Track 2: Press 2
Track 16: Press 10+ and 6
Track 22: Press 10+ two times and then 2
Repeat
During playback you can choose to repeat single tracks
or multiple tracks.
1: Press the REPEAT button (34) on the remote control
to repeat the current track. You will see the
icon
flash on the display.
2: Press the REPEAT button again to repeat all tracks
on the current disc. You will see the
icon stop
flashing and remain solid.
3: To cancel the repeat function press the REPEAT
button once more. The
icon will disappear from
the display.
Random
1: During CD playback pressing the RANDOM button
(35) on the remote will playback all tracks on the
current disc in a random order. You will see ‘RAN’
appear on the display to indicate this function is
active.
2: Press the RANDOM button once more to cancel the
function. The ‘RAN’ icon will disappear.
Program
It is possible to program a playback sequence up to 20
tracks using this function.
1: Press the STOP button (1, 28) to stop playback (if
required).
2: Press the PROG button (49) on the remote control.
You will see ‘P01’ on the display to indicate the
program function is active.
3: Use the NUMERIC buttons (22) to enter the track
number you want to play in slot P01.
4: Press the PROG button once more to proceed to
slot P02. When ‘P02’ appears on the display you can
repeat step 3 and enter the track number of slot P02.
5: Repeat steps 4-5 until you have programmed all
tracks you want in the sequence.
To Next Page
Loading...
