Page 7
Program (cont)
6: To begin playback of the programmed sequence
press the PLAY/PAUSE button.
7: To cancel playback press the STOP button.
Intro
1: Press the INTRO button (32), you will see ‘INTRO ON’
appear on the display. The first 15 seconds of each
track on the current disc will now play.
2: Press the INTRO button again to cancel. You will see
‘INTRO OF’ appear on the display.
Dab operation
Getting started
Before attempting to tune a radio station the
telescopic antenna needs to be extended fully.
R
SPEAKER
+
-
L
+
-
LINE-IN
1: Select DAB mode using the instructions from the
‘Switching modes’ section.
NOTE: There are two radio source options. When
you see RADIO on the display the first press is
DAB mode the second press is FM mode.
2: Alternatively you can press the DAB/FM button
(47) on the remote to jump to DAB mode (from any
mode other than radio), or press repeatedly to cycle
between DAB & FM.
3: When the DAB mode is activated for the first time the
unit will perform a scan for available stations. You will
see ‘SCAN 0’ appear on the display until stations are
located and then the ‘0’ will change to the amount of
stations found. When complete the first alphabetical
station will begin playback unless no stations were
located.
Getting started (cont)
NOTE: If no stations where located during the
scan, relocate the unit, extend the antenna fully
and read the ‘Manual Tuning’ section on page 8.
Listening to the stored dab stations
1: To listen the DAB stations that have been stored press
either CH- / CH+ button (10,13) main unit or (44,25)
on the remote to cycle through the list.
2: Press the
PLAY/PAUSE button (7) main unit or
ENTER (45) to tune to the selected station.
Storing station presets
It is possible to store up to 10 of your favourite stations
to the preset keys.
1: Tune to the station you wish to store as a preset and
follow the below instructions.
2: Press and hold the SAVE button (40). The display
will show ‘EMPTY 1’, where ‘1’ is the selected preset
location.
3: Use the CH- / CH+ buttons (44,25) to select the
preset number from 1-10 you wish to use. Then press
the ENTER button (45) to store.
4: When stored the display will show ‘STORED’.
NOTE: Once a station is saved to preset location
1 you will no longer see ‘EMPTY 1’ when pressing
and holding the SAVE button, instead the saved
station name will appear.
Recalling station presets
1: To recall a stored preset station press the relevant
numeric button (22) on the remote control.
For example to recall the station stored on preset
3 press the numeric button ‘3’. And to recall a
station stored on location 10, press the ‘0’ button.
User instructions
To Next Page
Loading...
