Need help?Do you have a question about the BWT PRO A 22 and is the answer not in the manual?
General| Brand | BWT |
|---|---|
| Model | PRO A 22 |
| Category | Water Filtration Systems |
| Language | English |
Diagram and instructions for connecting the device within the pool's hydraulic circuit.
Instructions for wiring the control panel to the cell and gas sensor, with warnings about cable modification.
Detailed guide to making internal connections within the control panel for various components and options.
Information on power supply requirements and how to slave the filtration pump.
Guidance on connecting and shunting for variable speed pump integration.
How to measure and calculate the amount of salt needed, with examples provided.
Guidance on empirically adjusting Chlorine and pH levels if optional kits are not installed.
Steps to configure language, time, date, screen settings, sound, and password.
How to select and adjust Chlorine production level, boost mode, and cover reduction.
Accessing sensor calibration and set point configuration for pH and Redox.
Procedure to set target pH and Redox values, and how pH regulation works.
Instructions for calibrating the pH and Redox sensors using buffer solutions or manual offset.
Procedure for quick pH sensor calibration using another measurement device.
Steps for calibrating the Redox sensor using a 465 mV buffer solution.
Procedure for quick Redox sensor calibration using another measurement device.
Instructions for calibrating the temperature sensor against a known accurate thermometer.
Steps to connect to a Wi-Fi network, select an access point, and configure system settings.
How to check connection status and register the device for remote control.
Guidelines for handling, cleaning, and de-scaling pH and Redox sensors.
Step-by-step instructions for de-scaling the electrolysis cell electrodes.
Procedures for passive and active winterization of the system components.
To Next Page