How to fix a considerable drop in water pressure in BWT Infinity A?
If the water pressure in your network has dropped considerably when using a BWT Water Filtration System, it might be due to a dirty filter element. Try performing a backwash to resolve this.
What to do if the flushing water outlet does not close in BWT Infinity A Water Filtration Systems?
If the flushing water outlet on your BWT Water Filtration System does not close, it could be due to large particles of dirt preventing the backwash element from reaching the end position. Try repeating the backwash several times. Alternatively, unscrew the wastewater connection and clean the vent tube outside.
Why does my BWT Infinity A Infinity AP display show ERR?
If the BWT Water Filtration System's display shows ERR, it might be due to low pressure. Try repeating the backwash several times and increase the pressure.
What to do if my BWT Water Dispenser display shows ERR?
If the display shows 'ERR', it indicates that the pressure is too low. First, check that the inlet pressure is more than 350 kPa. If it is not, increase the pressure. Then, perform a backwash.
Why does the flushing water outlet on my BWT Water Dispenser not close?
The flushing water outlet may not close because the backwash element does not reach the end position due to large particles of dirt. To resolve this, repeat the backwash process by turning the power on and off.
How to fix a drop in water pressure in my BWT Water Dispenser?
A drop in water pressure may be caused by a dirty filter screen. To fix this, complete a backwash and re-evaluate the frequency setting.
Specifies the product for which this documentation is valid.
Explains symbols used in the documentation for product recycling.
Provides general safety guidelines to follow before and during product use.
Details safety instructions relevant to specific actions on the device.
Outlines the required qualifications for installation and maintenance personnel.
Describes the primary purpose of the Infinity backwash filters for water filtration.
Lists actions that constitute misuse of the system.
States the manufacturer's liability limitations.
Refers to other supplier documents included with delivery.
Explains the primary purpose of filtering sediment from water.
Lists various applications where the filters are suitable for use.
Step-by-step instructions for connecting the filter to the connection module.
Details how to connect the flushing water hose to the drain.
Explains how to set the backwash interval timer on the filter.
Details electrical interlocking for multiple filters in parallel operation.
Guides on adjusting the backwash interval based on water quality.
Explains how to manually initiate a backwash cycle.
Describes the information shown on the filter's display.
Provides instructions for cleaning the plastic parts of the filter.
Lists common faults, their causes, and recommended actions for resolution.
Presents graphs illustrating pressure drop versus flow rate for DN 25 and DN 50 models.
Explains the purpose and content of the product's type label for identification.
Details the process for safely shutting down and dismantling the product.
Provides guidance on proper disposal and recycling of the product.
General| Brand | BWT |
|---|---|
| Model | Infinity A |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
