1 About This Documentation
1.1 Validity of this documentation
This documentation is valid for the following
product:
Infinity A backwash filter
This documentation is intended for operators,
end users, installation technicians not trained by
BWT, installation technicians trained by BWT (e.g.
“Trinkwasserprofi” or drinking water specialists) and
BWT service technicians.
This documentation contains important information
about how to safely and properly install the pro-
duct, how to start up, operate, use, maintain and
dismantle the product as well as how to remedy
simple faults on your own.
Please read this documentation in its entirety before
working with the product, especially section 2,
Safety Instructions, on page 4.
1.2 Symbols used
This symbol indicates that the
product can be recycled after it is
decommissioned.
2 Safety Instructions
The product was manufactured according to all
recognised regulations and technical standards and
was in compliance with the relevant legal require-
ments when it was put into circulation. Neverthel-
ess, it can pose a risk of personal injury or property
damage if you do not observe this chapter and the
safety instructions throughout this documentation.
● Carry out only those activities that are descri-
bed in this operating manual, unless you have
been trained by BWT.
● Carry out all activities in accordance with all
applicable standards and requirements.
● Instruct the operator of the product on the
product’s function and how to use it.
● Inform the operator of the product about how
to maintain the product.
● Inform the operator of the product about the
possible hazards that may arise when opera-
ting the product.
2.1 General safety instructions
● Read this documentation carefully and in its
entirety before working with the product.
● Store this documentation so that it is acces-
sible to all users at all times.
● Include the complete documentation if you
transfer the product to a third party.
● Follow all instructions regarding proper use of
the product.
● If you notice damage to the product or the
mains supply line, cease operation immedia-
tely and inform the service personnel.
● Use only accessories, spare parts and consu-
mables that have been approved by BWT.
● Adhere to the environmental and operating
conditions specified in the “Technical Data”
section.
● Wear personal protective equipment. This
equipment is for your own safety and will
protect you from injury.
To Next Page
Loading...
