EasyManua.ls Logo

BYD SEAL - Page 110

BYD SEAL
216 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The vehicle cannot power on when
The vehicle cannot power on when:
After you press the START button, the
smart key warning light turns on, a
beep sounds, and the message "No
key detected" is displayed on the
instrument cluster. This means that
the key is not in the vehicle or cannot
be detected due to interference.
The key is somewhere unsuitable for
detection, such as on the 󽗊oor, in the
cup holder, trunk, etc.
Pressing the START button may not
enable the start function due to:
If the electronic smart key does not
work, the smart key system warning
indicator on the combination
instrument 󽗊ashes, and the message
"Low key battery" is displayed on
the information display screen in
the middle of the combination
instrument, indicating that the key
battery may have run out. Replace
the electronic smart key battery as
soon as possible with reference to
the operation procedure given in
"Smart Key Battery Runs Out".
Except for causes mentioned above,
the PEPS system also fails to work
normally under some conditions due
to di󽗈erent service environments.
See "Smart Access and Start System"
for relevant details.
Starting the vehicle in emergencies
Engage the parking brake 󽗉rmly.
Turn o󽗈 all lights and accessories.
The gearshift lever is on "P".
Switch the ignition o󽗈.
The electronic smart key is in the
vehicle.
Press and hold the smart key start
button for over 15 seconds.
Check after starting
Instrument cluster: Con󽗉rm that
the maintenance indicator and the
speedometer work normally.
Brakes: In a safe area, verify that the
vehicle maintains a straight direction.
Other abnormalities: Check for loose
parts, leaks, and unusual noises.
If everything is OK, just enjoy your
driving.
Remote Start*
Electronic Smart Key “Remote Start
Function”
1. Press and hold the remote start/stop
button on the electronic smart key for
2 seconds to start the vehicle. After it is
started, turn signals 󽗊ash 3 times.
2. If there is no valid operation within 10
minutes after remote start, the vehicle
stops and powers o󽗈, and turn signals
󽗊ash twice.
109
04
USING AND DRIVING

Related product manuals