BYD SEAL - Page 133

lane or a vehicle approaching quickly on
the adjacent lane, the indicator on the
corresponding side mirror lights up. If the
turn signal for the same side is turned on
at this moment, the alarm indicator on
the side mirror 󽗊ashes to alert the driver
of a risky lane change.
Rear Cross Tra󽗋c Alert (RCTA)*
When the vehicle is reversing at a
speed no more than 15 km/h, the RCTA
system detects the vehicles traveling
in the blind spot at the back through
rear corner mmWave radars. If the
system determines that other vehicles
approaching from behind may cause a
collision, the indicators on side mirrors
will 󽗊ash and the buzzer will sound to
remind the driver and thus reduce the
possibility of collision.
Rear Cross Tra󽗋c Braking (RCTB)*
When the vehicle is reversing at a speed
no more than 9 km/h, the RCTB system
detects the vehicles traveling in the blind
spot at the back through rear corner
mmWave radars. If the system judges that
a vehicle approaching from behind poses
a risk of collision, emergency braking is
performed automatically.
Rear Collisions Warning (RCW)*
At vehicle speeds between 5-146 km/h,
if rear corner mmWave radar sensors
detect a risk of collision with a vehicle
approaching too quickly from behind on
the current lane, the hazard warning light
turns on to warn the driver in that vehicle
against a possible collision.
Door Open Warning (DOW)*
DOW is realized with rear corner mmWave
radars installed on both sides of the rear
bumper. When the vehicle is stationary
with doors unlocked, the system keeps
indicators on side mirrors solid on to
warn the driver if moving objects, such as
bicycles or automobiles, approach from
behind on an adjacent lane. If the driver
attempts to open the door at this time,
indicators on side mirrors begin to 󽗊ash
and a chime sounds.
Cruise Button Operation
●
To enable or disable BSD, RCTA, RCTB,
RCW and DOW, go to Infotainment
touchscreen
→ ADAS → Active
Safety → Blind Spot Assist. The system
defaults to the previous settings when
the vehicle starts.
●
When the blind spot assist system is
disabled, no relevant indicators are
displayed on the cluster.
●
When the blind spot assist system is
standing by, if vehicle conditions, such
as speed or gear status, do not meet
the requirements of any function, a
gray indicator
is displayed on the
cluster and blind spot assist will not be
activated.
132