BYD SEAL - Page 134

●
If the blind spot assist system
malfunctions,
is displayed on the
cluster.
●
When the blind spot assist system
is active, a green indicator
is
displayed on the cluster, meaning that
the function has been activated and
can trigger alarms at any time.
Precautions
●
While the BSD system provides
assistance in monitoring blind spots
of rearview mirrors, it cannot replace
the driver's observation and judgment.
The driver must keep control of vehicle
at all times and drive properly and is
fully responsible for the vehicle.
●
The BSD system may be unable to
provide adequate warning on target
vehicles approaching from behind at a
high speed.
●
The driver must ensure the normal
operation of the BSD system, keeping
its rear corner mmWave radars in good
condition. For example, dirt, snow, or
other obstructions need to be cleared
right away.
●
The BSD system gives a warning if
unrelated targets at the rear side or in
the rear (such as work zone barriers,
large roadside billboards, re󽗊ectors
in tunnels, or other objects with a
large radar cross section) are wrongly
selected as target vehicles.
●
Detection may be a󽗈ected or delayed
in some environments. If the radar
cross section of the target vehicle is
too small (a bicycle, electric moped or
pedestrian, for example), the system
may fail to identify targets, leading
to false alarms. In addition, detection
may also be a󽗈ected or delayed by
noise or electromagnetic interference.
System Limitations
●
Under some circumstances, it will be
di󽗋cult for the system to assist the
driver, and detection may be a󽗈ected
or delayed. Possible circumstances
include, but are not limited to:
●
The vehicle coming from behind
changes the lane suddenly.
●
Vehicles coming from behind are
detected too late at sharp turns,
slopes, or other settings.
●
The target vehicle is obscured.
●
Vehicles come from behind at a
relative speed above 80 km/h.
●
The vehicle is on a curve which is
too sharp, or is entering or exiting a
curve.
●
The vehicle is running under severe
weather, such as rain or snow.
●
Rear corner mmWave radar(s) come
o󽗈, are loosely installed, or are
blocked.
●
The vehicle encounters certain metal
guardrails or similar road conditions.
●
Targets that may not be responded
include, but are not limited to,
pedestrians and animals.
●
The environment contains
electromagnetic interference or
other in󽗊uences.
●
Vibration or collision in󽗊uence on
sensor calibration of BSD's rear corner
mmWave radars can degrade system
performance. If this is detected,
contact a BYD authorized dealer or
service provider.
WARNING
●
Blind spot assist only serves as a
driver assistance function, so the
133
04
USING AND DRIVING