BYD SEAL - Page 140

Parking Assist System
●
During vehicle parking, the parking
assist system detects obstacles by
sensors, and prompts the driver with
the proximity of obstacles by an image
on the infotainment touchscreen and a
speaker alarm.
●
The parking assist system helps
with reversing. Pay attention to the
environment behind and around the
vehicle during reversing.
●
When you reverse the vehicle, a
reversing image will be displayed
on the infortanment touchscreen
automatically.
●
After reversing ends, the interface will
be restored.
REMINDER
●
The safety lines for reversing are
only for distance reference in no-
load condition of the vehicle.
●
For your driving safety, when the
reversing image is displayed, all
buttons will be disabled except
some volume and phone related
buttons.
WARNING
●
The parking assist system ceases
to operate when the vehicle is
moving forward at over 10 km/h.
●
Do not place any articles within
the sensors' working range.
●
To prevent sensor malfunction, do
not wash the sensor area with
water or steam.
Reversing Radar Power Switch
●
To enable or disable the reversing
radar system, go to Infotainment
touchscreen
→ ADAS → Parking
Assist.
●
When the ignition is on and EPB is
released, the parking assist system is
enabled automatically.
●
When enabled, the system raises
an alarm if obstacles are found
surrounding the vehicle; when
disabled, it does not.
Sensor Type
●
When the sensor detects an
obstacle, the corresponding image is
displayed on the infotainment screen*,
depending on the location of the
obstacle and its distance from the
vehicle.
●
When the driver conducts parallel
parking or reverse parking, the
sensor measures the distance between
the vehicle and the obstacle
and communicates this information
through the infotainment screen
and the speaker. Be aware of the
surroundings when using this system.
①Front right sensor
②Front left sensor
③Rear right sensor
④Rear left center sensor and rear right
center sensor
139
04
USING AND DRIVING