BYD SEAL - Page 146

of rear wheel is high, ABS adjusts the
brake pressure of rear wheel for a
smoother and more ideal brake force
distribution.
WARNING
●
ABS cannot work e󽗈ectively under
the following conditions:
●
Tires with inadequate grip are
used (e.g., excessively worn tires
used on snow-covered roads).
●
The vehicle skids when driving
at a high speed on slippery
roads.
●
ABS is not designed to reduce the
braking distance of the vehicle.
Always keep a safe distance from
the vehicle ahead when:
●
Driving on slippery, muddy,
sandy or snowy roads.
●
Driving on roads with multiple
potholes or on uneven roads.
●
Driving on bumpy roads.
CAUTION
●
If the ABS fault warning light is
still on while the braking system
warning light is on, immediately
park the vehicle in a safe place.
It is recommended to contact a
BYD authorized dealer or service
provider.
●
In this case, if brakes are applied,
the ABS will not work and the
vehicle will become extremely
unstable.
●
ABS does not reduce the time
and distance required to stop the
vehicle. This device only helps you
control steering when braking.
Please always keep a safe distance
from other vehicles.
CAUTION
●
ABS cannot prevent skidding
caused by sudden direction
change, such as trying to make
a sharp turn or change lanes
suddenly. Always drive carefully at
a safe speed, regardless of road
and weather conditions.
●
ABS does not prevent decrease
in stability either. When applying
the brake in an emergency, the
steering should be moderate. A
large or sharp turn during the
driving can cause the vehicle to
swerve into oncoming tra󽗋c or
run o󽗈 the road.
●
When driving on wet or soft
or uneven roads (such as
waterlogged concrete roads,
waterlogged epoxy painted roads,
sandy roads, snowy roads),
vehicles equipped with ABS may
require longer braking distances
than vehicles without ABS. In such
cases, reduce the vehicle speed
and keep a greater distance from
other vehicles.
Intelligence Torque
Adaption Control (iTAC)
System*
When the vehicle is running, the
intelligence Torque Adaption Control
(iTAC) system can determine the driver's
driving needs and vehicle state according
to the information such as steering wheel
angle and motor speed, quickly identify
the vehicle state through the unique
control architecture and algorithm, and
dynamically adjust the driving torque
of the front and rear axles, so that
the driving state of the vehicle can
better meet the driver's needs and
the vehicle can still obtain better
145
04
USING AND DRIVING