BYD SEAL - Page 197

3. Release its supports to create a pattern
as shown.
Using tire repair device
●
The tire repair device is used to
seal small cuts, especially cuts in
tread pattern. It is just an emergency
solution for you to drive to the nearest
service center, and only for short
emergency stretches, even if the tire is
not de󽗊ated.
WARNING
●
The tire repair kit is only suitable
for minor damages of tires. If a
wheel is damaged, tire puncture
sealant kit is prohibited.
●
Tire sealant is highly 󽗊ammable
and harmful to health. Take
necessary precautions to prevent
󽗉re and avoid contact with skin,
eyes, and clothing; keep away
from children; and do not inhale
its vapor.
In case of contact with tire sealant:
●
If tire sealant comes into contact
with the skin or gets into
the eyes, thoroughly 󽗊ush the
a󽗈ected body part immediately
with plenty of clean water.
●
Change contaminated clothing
immediately.
WARNING
●
In case of an allergic
reaction, seek medical attention
immediately.
●
If tire sealant is ingested by
accident, rinse mouth thoroughly
and drink plenty of water
immediately. Do not induce
vomiting, but seek medical
attention immediately.
How to Use the Tire Repair Device
●
Refer to the labels on the in󽗊ator for
details on how to use the tire repair kit.
●
If the in󽗊ator needs to be connected
to a power source, plug the in󽗊ator
into the vehicle’s 12V socket, start the
vehicle, and switch on the in󽗊ator. The
tire sealant is then 󽗉lled through the
in󽗊ator hose into the tire along with
air.
REMINDER
●
Make sure the in󽗊ator switch is o󽗈
when plugging the power supply
into the 12V socket in the vehicle.
●
The in󽗊ator can only be turned on
for up to 10 minutes.
●
Observe the tire pressure gauge
reading on the in󽗊ator.
●
If the tire pressure does not reach
180 kPa within 10 minutes (red area
196