EasyManua.ls Logo

BYD SEAL - Low-Voltage Battery Issues

BYD SEAL
216 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
shown in the 󽗉gure), turn o󽗈 the
in󽗊ator. You are recommended to
contact a BYD authorized dealer or
service provider.
If the tire pressure reaches between
180 and 320 kPa (green and yellow
areas shown in the 󽗉gure), remove
the kit as soon as possible and drive
at a speed below 80 km/h within
one minute, with the furthest driving
distance not exceeding 10 km, so that
the tire sealant is evenly distributed
within the tire.
Observe the tire pressure gauge
reading on the in󽗊ator.
If the tire pressure is greater than
220 kPa, drive to the nearest service
center at a speed below 80 km/h.
If the tire pressure is between 130
and 220 kPa, repeat the process
to 󽗉ll the tire sealant into the tire
and observe the tire pressure gauge
reading on the in󽗊ator.
If the tire pressure does not reach 130
kPa, it is recommended to contact
a BYD authorized dealer or service
provider.
REMINDER
Using tire repair device on
damaged tires is only an
emergency solution. Please
change the tires at a professional
repair center as soon as possible.
It is recommended that you
contact a BYD authorized dealer
or service provider and inform the
maintenance technician that the
tires contain tire sealant.
After repairing a tire with the tire
repair device, it is recommended
that you purchase new tire
sealant and in󽗊ation hoses at a
BYD authorized dealer or service
provider.
Avoid hard acceleration and high-
speed turns.
Do not exceed the 80 km/h
maximum speed limit and replace
󽗊at tires as soon as possible. Do
not drive further if the vehicle
experiences strong vibration,
unstable performance, or noise.
When the tire sealant is about
to expire (see the label on the
canister for exact date), replace it
with a new one.
If the Low-Voltage Battery
Is Exhausted
When the vehicle cannot start due to
under voltage of low voltage distribution
box, try to start it as per the following
steps:
1. Open the Hood.
2. Remove the left trim panel of front
compartment.
197
07
WHEN FAULTS OCCUR

Related product manuals