3. Connect one end of the red positive (+)
cable to the positive (+) terminal of the
undercharged low voltage distribution
box of the vehicle under rescue.
4. Connect the other end of the red
positive (+) cable to the positive (+)
terminal of the charged low voltage
distribution box of the rescue vehicle.
5. Connect one end of the black negative
(-) cable to the negative (-) terminal of the
charged low voltage distribution box of
the rescue vehicle.
6. Connect the other end of the black
negative (-) cable to an applicable
tie point (clean, unpainted, solid and
grounded metal part) of the vehicle under
rescue.
7. Start the rescue vehicle and keep it
running for a while. Then try to start the
vehicle under rescue.
8. After the vehicle under rescue starts
normally, turn o the power of the rescue
vehicle, remove the jumper cables orderly
reverse to connection, and put them
away.
9. Install the hood trim panel, and close
the hood.
WARNING
●
Connecting or disconnecting
jumper cables in the wrong
order may lead to an electrical
short circuit, resulting in vehicle
damage or personal injury.
●
To prevent a short circuit in the
jump start, jumper cable clamps
shall not contact each other or
any conductive material other
than the jumper points.
CAUTION
●
If the vehicle being rescued
cannot be started after several
attempts, contact a BYD
authorized dealer or service
provider.
●
The battery rated voltage of the
rescue vehicle for jump start shall
be 12 V.
If the Vehicle Needs
Support
If the vehicle needs to be lifted or jacked,
the lifting arm or jack can only be placed
at the lifting points as shown in the gure.
●
Pay attention to the followings when
lift or jack the vehicle to ensure safety:
198
To Next Page
Loading...
