BYD SEAL - Page 29

CAUTION
●
Push/Pull the child seat in
di󽗈erent directions to ensure it is
securely installed.
●
If the driver seat obstructs the correct
installation of the CRS, install it on the
right rear seat.
●
Never install a rear-facing child
restraint on the seat protected by
a front airbag (in the active state),
otherwise in the event of an accident,
the force of rapid deployment of the
front passenger airbag will result in
death or serious injury to the child.
Always follow the instructions below
when using a child restraint on the
front passenger seat:
●
Never use a rearward-facing child
restraint on the front passenger seat
if the airbag is activated. The airbag
must be activated immediately after
the rearward-facing child restraint
system is dismounted from the front
passenger seat.
●
If needed, adjust the front passenger
seat backwards so that there is no
contact between the child and vehicle
interior.
●
If needed, the front passenger
seatback and seating height can be
adjusted so that it has secure contact
with the child restraint system.
●
For child restraint systems with the
guide 󽗉tting of belt attached to the
child seat headrest, ensure that the
guide 󽗉tting is positioned forward or in
line with the seat belt upper anchorage
on the vehicle's B-pillar.
●
When a forward-facing child restraint
system is used on the front passenger
seat, ensure that the seat is positioned
fully rearward away from the active
airbag.
●
Ensure that the seat belt passes
through the guide 󽗉tting without
kinking and is not bent over the edge
of the guide 󽗉tting.
Always follow the instructions below
when using a child restraint on a rear
seat:
●
If there is no front passenger, the front
passenger seat can be adjusted to
make sure there is enough space for
the rear child seat.
●
The head restriant can be adjusted
or even removed to ensure that the
vehicle seatback can safely support the
child restraint system.
●
When a child restraint is without
seatback, never remove the head
restriant from the vehicle and adjust it
to locking position.
●
When the top tether is used on a
outboard rear seat, route it at the
outside of each head post.
●
For more installation instructions,
please read the instructions provided
with your child restraint system.
Details on child restraint system
installation:
① Driver seat
② Front passenger seat
③ Rear left seat
④ Rear center seat
28