BYD SEAL - Page 28

Installing child restraint systems:
1.
Open the anchorage lever trim cover
and install the child restraint system to
the seat.
REMINDER
●
The anchorage lever is located on
the bevel at the rear end of the
seat cushion. It is visible when the
lower part of the child seat trim
cover is pressed. After the child
seat is removed, the upper part of
its cover needs to be pressed to
return the cover.
WARNING
●
When using the lower anchoring
device, make sure that no foreign
objects are around the anchoring
device and that the seat belt is not
stuck behind the child seat; make
sure that the CRS is securely 󽗉xed.
Otherwise emergency parking or
WARNING
an accident may result in serious
injury to the child or even death.
2. Open the anchor support cover.
3.
Fasten the snap hook to the anchor
support and tighten the top tether to
ensure the strap is buckled securely.
① Top tether
② Anchor support
③ Snap hook
REMINDER
●
If the CRS is equipped with a top
tether, secure the tether to the
anchoring device.
27
01
SAFETY