Company Address: Room 601, Floor 6, Building F, Songbai Road 1008, Sunshine Community，Xili Street, Nanshan District, Shenzhen(518108)
Factory Address: Fl1, Bldg B, Wentao Industrial zone, Yingrenshiyongxin Village, Shiyan Street, Baoan district, Shenzhen, Guangdong, China (518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
9
4.3 LOID Authentication Config
LOID of ONU is mainly applicable of the authentication mode of LOID and LOID +
Password for ONU. By default,EPON ONU registers for the OLT by MAC and rarely uses LOID
for register. Normally, we needn’t to configure LOID. But the configuration as follows:
1. Login ONU WEB, select Internet -> Remote Mgmt -> LOID, view or configure LOID
and password of ONU：
5 Basic Configuration for Internet
Home Gateway Unit (HGU) ONU supports route function, so that there are route mode and
bridge mode for internet. The difference between route mode and bridge mode as follows :
Route mode：ONT as a home gateway equipment, ONT IP address can be obtained in three
ways, which includes DHCP, Static IP Address and PPPoE. The IP address of the device on the
user side is obtained through the DHCP address pool of the ONT, or by manually setting;
Bridge mode：The ONT does not obtain the IP address assigned by the upper device or can
not manually set the static IP address. It is used as a relay device and does not process the data.
There are three ways to obtain the IP address of the user side device, namely DHCP, PPPoE,
Static IP Address.
5.1 Route Mode Configuration
5.1.1 Configure PPPoE WAN Connection for Internet in Route Mode
1. Login ONU WEB, select Internet -> Internet Config -> Internet Config, and then there
are some parameters for us to configure as follows:
【WAN Connection name】Select ‘Add WAN Connection’
【Mode】Select ‘ Route ’
【 Connection Mode 】 Select ‘Ipv4’; If there is Ipv6 in the network, we can select
‘Ipv4/Ipv6’.
To Next Page
Loading...