EP203 AUTOMATIC EXTINGUISHER PANEL
Page 10 of 45 • EP203 AUTOMATIC EXTINGUISHER PANEL INSTALLATION MANUAL • Approved Document No. DFU0002032 Rev 4
6. Carefully remove the two retaining screws on the Power Supply PCB and slide the PCB
up and over its mounting pillars, taking care not to damage any of the components.
7. If an Output Expansion Relay Board is fitted, carefully remove the two retaining
screws on the board and slide the board up and over its mounting pillars, taking care
not to damage any of the components.
8. Store the PCBs in a clean, dry place that is free from vibration, dust, and excessive
heat. Storing the PCBs in a suitable cardboard box will also guard them against
mechanical damage.
To Next Page
Loading...
Need help?
General
