EP203 AUTOMATIC EXTINGUISHER PANEL
Approved Document No. DFU0002032 Rev 4 • EP203 AUTOMATIC EXTINGUISHER PANEL INSTALLATION MANUAL • Page 25 of 45
Display Faults
This menu displays all faults on the system and is available at both Access Levels 2 and 3:
1. In Access Level 3, select the Display Faults menu. The panel displays all active faults
on the system. (e.g. Zone 1 O/C Fault, Zone 2 S/C Fault, etc.)
2. Scroll the display through all active faults using the Scroll (up) and Scroll (down)
buttons.
3. Press the Escape button to return to the Access Level 3 menu.
Display Dis/mnt
The Display Disablements menu displays all active disablements on the system and is
available at both Access Levels 2 and 3. Disablements are set in the Disablements menu
(see Page 26).
1. In Access Level 3, select the Display Dis/mnt menu. The panel displays all active
disablements on the system (e.g. Zone 1 disabled, etc.).
2. Scroll the display through all active disablements using the Scroll (up) and Scroll
(down) buttons.
3. Press the Escape button to return to the Access Level 3 menu.
Zones in Test
This menu displays all detection zones that are currently in test mode on the system and
is available at both Access Levels 2 and 3. Zones are put in test mode in the Engineering
menu (see Page 32).
1. In Access Level 3, select the Zones in Test menu. The panel displays all zones
currently in test on the system (e.g. Zone 1 is on Test, etc.).
2. Scroll the display through all active zones in test using the Scroll (up) and Scroll
(down) buttons.
3. Press the Escape button to return to the Access Level 3 menu.
Display RSUs
This menu displays all active Remote Status Units on the system.
1. In Access Level 3, select the Display RSUs menu. The panel automatically displays all
RSUs and their IDs.
2. Press the Escape button to return to the Access Level 3 menu.
To Next Page
Loading...
Need help?
General
