EP203 AUTOMATIC EXTINGUISHER PANEL
Page 4 of 45 • EP203 AUTOMATIC EXTINGUISHER PANEL INSTALLATION MANUAL • Approved Document No. DFU0002032 Rev 4
IMPORTANT NOTES
THI S EQUIPMENT MU ST ONL Y BE I NSTALLED AND MAI NTAINED BY A
SUITABL Y S K IL LED AND TECHN ICALL Y COMPETENT PERS O N.
Equipment Guarante e
This equipment is not guaranteed unless the complete system is installed and
commissioned in accordance with the laid down national standards by an approved and
competent person, or organisation.
This product has been manufactured in conformance with the requirements of
all applicable EU Council Directives
Items supplied with the EP203 panel:
• Installation and Maintenance Manual – Document No. DFU0002032 (this manual)
Note: This manual MUST NOT be left accessible to the general user.
• User Manual/Log Book – Document No. DFU0002031
• Shortform Installation Instructions – Document No. DFU0002033
• Accessory pack containing the following items:
1 x Allen key (for unfastening/securing the panel lid)
12 x 6K8, 0.25W (end-of-line resistors)
1 x 1A HRC, 20mm ceramic fuse (spare mains supply fuse F1)
1 x 5A F, 20mm glass fuse (spare battery fuse F2)
1 x set of battery connection leads (red lead, black lead, green jump lead)
1 x set of links for PLK1 & PLK2.
Sys tem Design
Fire alarm system and extinguisher system design are beyond the scope of this
document. A basic understanding of general system components and their use is
assumed.
To ensure a reliable system and limit the consequences of faults, we strongly
recommend that a suitably qualified and competent person is consulted in connection
with the design of the fire alarm and extinguisher system and that the system is
commissioned and maintained to local design and installation regulations. The fire
officer concerned with the property should be contacted at an early stage in case he has
any special requirements.
The EP203 Automatic Extinguisher Panel (hereafter called the EP203 panel) is compliant
with the following European standards:
• EN 12094-1 – Fixed firefighting systems – Components for gas extinguishing
systems - Part 1: Requirements and test methods for electrical automatic control
and delay devices
• EN54-2 and EN54-4 – Fire Detection and Fire Alarm Systems –
Control and Indicating Equipment (EN54-2); Power Supply Equipment (EN54-4).
To Next Page
Loading...
Need help?
General
