EP203 AUTOMATIC EXTINGUISHER PANEL
Approved Document No. DFU0002032 Rev 4 • EP203 AUTOMATIC EXTINGUISHER PANEL INSTALLATION MANUAL • Page 27 of 45
Di sable Inpu t
This sub-menu allows the disabling/enabling of one, or more of the panel’s six
monitored inputs: Manual Release, Flow Switch, Low Pressure, Mode, Hold and Abort.
1. From the Disablements menu, select Disable Input.
2. Select the input(s) to be disabled/enabled using the Scroll (up) and Scroll (down)
buttons.
3. Press the Accept button to disable/enable the selected input.
4. Press the Escape button to return to the Disablements menu.
Di sable Re lay
This sub-menu allows the disabling/enabling of one, or more of the panel’s six auxiliary
relay outputs: Fire, Local Fire, Extract, 1st Stage, 2nd Stage and Fault.
Note: If an Output Expansion Relay Board is fitted, this sub-menu also allows the
disabling/enabling of one, or more of the board’s five relay outputs: Reset, Mode,
Discharged, Hold and Abort.
1. From the Disablements menu, select Disable Relay.
2. Select the relay output(s) to be disabled/enabled using the Scroll (up) and Scroll
(down) buttons.
3. Press the Accept button to disable/enable the selected relay output.
4. Press the Escape button to return to the Disablements menu.
Di sable RS U
This sub-menu allows the disabling/enabling of one, or more of the panel’s Remote
Status Units.
1. From the Disablements menu, select Disable RSU.
2. Select the RSU(s) to be disabled/enabled using the Scroll (up) and Scroll (down)
buttons.
3. Press the Accept button. The panel requests confirmation.
4. Scroll (down) to confirm the change.
5. Press the Accept button to disable/enable the selected RSU. The Disablements menu
is displayed.
Note: ‘RSU Disabled’ will be displayed at the RSU that has been disabled.
To Next Page
Loading...
Need help?
General
