Cadac J-Type - Page 108

4-22 7548 Programmable Routing - Slave Mod. Mk II
J-Type Revision J2005-2
7161< $)/#6ZLWFK
The AFL switch is provided to allow the operator to instantaneously “monitor” the
audio signal leaving the module. This is a latching switch, so that once depressed,
the AFL function stays in operation until cancelled by pressing the switch again.
Unlike PFL, the AFL function
is
affected by the position of the fader below the mod-
ule.
716143 0XWH
The
main
MUTE switch is included to allow the operator to instantaneously switch off
the audio signal leaving the module without disturbing the pre-set routing. This is a
latching switch, so that once depressed, the
mute
function stays in operation until
cancelled by pressing the switch again. This also has the CHECK MUTE functions,
the same as normal channels.
716144 ,QVHUW
A Send and Return
break-jack
facility is placed between the mixing amplifier and the
fader. This is to allow the signal to be sent out to and returned from an external pro-
cessing unit. A relay is used to switch the
insert
function “in” and “out”. When ‘insert’
is not selected, the signal is passed directly from the mixing stage to the fader and
hence the output routing.
Select INS to divert the incoming signal to an external device and have the pro-
cessed signal inserted into the routing path.
This function is recorded with the console status and may be programmed using the
Sound Automation Manager software.
716145 ,VROD WH
Press the Isolate switch to disconnect the module from the computer functions.
When a module is isolated, it cannot read switch data information from the CCM
local memories or the PC.
716146 5 HFDOO
At the present time the RECALL button has no other function other than to map the
router.