7925 Programmable Group Module 4-1
Revision J2005-2 J-Type
7 3URJU DPPDEOH#0RGXOHV#0#6XE/#
0DWUL[/#350#)#$X[
714 :<58#3URJUDPP DE OH#*URXS#0 RGXOH
The 7925 Group Module is fully programmable. All switch data, potentiometer posi-
tion recall data and Sub-to-Matrix Level data can be saved to and recalled from a
cue, using the CADAC
Sound Automation Manager
software.
The Sub Group has a VCA fader that can be controlled from any DC Master fader
installed in the console, and the fader position can be saved to a cue. The ‘Inject’
input has an On/Off switch and Level potentiometer. An ‘Insert’ facility is provided
and the Sub Group can be routed to the Sub-to-Matrix section ‘pre/post-fader’.
The Sub-to-Matrix section has a routing switch for each matrix bus, plus a VCA to
control the audio level. The VCA level is set using an assignable controller.
The module contains two Matrix Groups, labelled ‘A’ and ‘B’. Each Matrix Group has
‘Inject’ on/off and level pot, an ‘Insert’ facility and output level pot.
To Next Page
Loading...