7-4 6910 Oscillator, PFL & Stereo Aux module
J-Type Revision J2005-2
:141< 2XWSXW#WR#VXEV
Press the SUBS switch to route the selected oscillator to the Sub group mix bus, for
use with the Sub Groups.
No further switching is necessary on the Sub Groups.
:14143 2XWSXW#OHYHO#&RDUVH#DQG#)LQH
The output level of the selected oscillator source is controlled by the two potentiome-
ters labelled COARSE and FINE.
The COARSE control allows you to set the approximate output level required, and
the FINE control allows a precise output level to be set.
:14144 $X[#*URXSV#44#)#45#223#PHWHUV
Two 20 segment LED meters that show the output signal level being sent from the
Stereo Aux group.
7.1.11 Aux Groups 11 & 12 O/P
meters
7.1.12 Aux Groups 11 & 12 O/P fad-
ers
7.1.13 Aux Groups 11 & 12 PFL
switches
7.1.14 Aux Groups 11 & 12 MUTE
switches
9<43#2VFLOODWRU/#3)/#)#6WHUHR#$X[#PRGXOH
To Next Page
Loading...