CADDX xGenConnect - Page 129

xGenConnect Installation and Programming Guide 117
Notes
• If an event message is enabled in an Event List, then the Channel will attempt
to deliver it. If an event message is not enabled on the Event List, the
Channel will not attempt delivery even if the message has been sent to it.
• Event List set up for push notifications is automatically performed by the
UltraSync+ app when required. The panel will assign the next available
channel and matching event list number. No configuration via the web pages
or DLX900 is required.
Programming Sequence
17. Event Lists
5. Channels
→
6. Communicator
17. Event Lists
Instructions
1. Open Event Lists.
2. Enter a name for the list.
3. Check the events you want to include in the list.